1.5" CT Straight Joint Coiled Tubing Tools 200KN 35Mpa

1.5＂CT Straight Joint Coiled Tubing Tools

I. Overview:

Coiled tubing connector is used to connect coiled tubing with coiled tubing operation tools. It is the uppermost tool in coiled tubing operation.

II. Technical parameters:

1. coiled tubing specification: 1-1/2 ";

2. Breakthrough pressure: 35Mpa；;

3. Fishing neck: 2.313 ";

4. Size: 1-5/32 "; Safety load: 200KN.

III. Structural characteristics:

Coiled tubing connector is composed of coiled tubing connector, coiled tubing connector slip, backing ring, sealing ring top thread, etc. See the explanatory diagram for the specific structure.

IV. Precautions:

1. Before use, measure the outer diameter of coiled tubing. The tool is applicable to coiled tubing with a specification of 1.5 ",so the outer diameter of coiled tubing must be within the range of φ Φ38.1±0.25mm If it is out of tolerance, the outer diameter of coiled tubing must be ground within the above standard size;

2. Check the straightness of coiled tubing at the same time. The straightness of coiled tubing is ≤1mm/1m. If it is bent, it cannot be used, and the straight end must be re-cut for use;

3. After cutting the coiled tubing, it is necessary to ensure that the cutting end is flush, and the chamfer can be used only after grinding with a file to prevent the coiled tubing from cutting the sealing ring;

4. Make sure there is no leakage in the pressure seal test before use;

5. When temporarily not in use, apply lubricating oil to the seal, and put the thread belt thread protector away.

Welcome to contact us at any time.